Copystar 400ci Spécifications Page 50

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 488
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 49
Preparation before Use
2-10 OPERATION GUIDE
Network Setup (LAN Cable Connection)
The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP
(IPv4), TCP/IP (IPv6), IPX/SPX, NetBEUI, IPSec, and AppleTalk. It enables network printing on the Windows,
Macintosh, UNIX, NetWare and other platforms.
This section explains the TCP/IP (IPv4) Setup and AppleTalk Setup procedures. For other network settings,
refer to the Network Setup on 8-89.
TCP/IP (IPv4) Setup ...2-10
AppleTalk Setup ...2-12
NOTE: If user login administration is enabled, you can only change the settings by logging in with
administrator privileges. If user login administration is disabled, the user authentication screen appears. Enter
a login user name and password, and press [Login]. Refer to Adding a User on page 11-4 for the default login
user name and password.
TCP/IP (IPv4) Setup (by Entering IP Addresses)
Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway
addresses. The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off".
NOTE: Prior to the IP address entries, obtain permission from the network administrator.
Use the procedure below to setup the TCP/IP (IPv4) setting.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Change] of TCP/IP.
4 Press [On] and then press [OK].
5 Press [Change] of IPv4.
6 Press [DHCP].
7 Press [Off] of DHCP and then press [OK].
8 Press [Bonjour].
System - IPv4
Set TCP/IP (IPv4).
On
Default
Gateway
0.0.0.0
0.0.0.0
0.0.0.0
On
IP Address
Subnet Mask
Off
BonjourDHCP
Status 10/10/2008 10:10
Cancel
OK
Vue de la page 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 487 488

Commentaires sur ces manuels

Pas de commentaire